Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
NOTE: Stand battery upright before placing into battery
compartment.
•
Grab the red and black battery cables and pull towards
center of the battery crisscrossing the cables.
•
Place battery into battery compartment while holding
cables together.
CAUTION: Ensure battery cables are in the
battery compartment to prevent battery
cables from coming in contact with the tires.
•
Close battery door.
CABLES
TO REPLACE LED HEADLIGHT
•
Raise hood.
•
Disconnect harness from LED light.
•
Remove mounting screws to remove LED light, reflector
and lens.
•
Replace LED light, reflector, or lens as needed.
•
Reinstall using mounting screws previously removed.
•
Reconnect harness to LED light.
•
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
•
Check wiring.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
Fig. 52
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 53)
•
Raise hood.
•
Unsnap headlight wire connector.
•
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedure.
07002
TRANSMISSION
REMOVAL/RE PLACE MENT
Should your transmission require removal for service or
re place ment, it should be purged after reinstallation and
before operating the tractor. See "PURGE TRANS MIS SION"
in the Operation section of this manual.
ENGINE
TO AD JUST THROTTLE CON TROL CABLE
The throttle control has been preset at the factory and
ad just ment should not be necessary. If adjustment is nec-
es sary, see engine manual.
TO AD JUST CHOKE CON TROL
The choke control has been preset at the factory and ad just-
ment should not be necessary. If adjustment is necessary,
see engine manual.
28
HOOD
HEADLIGHT
WIRE
CONNECTOR
Fig. 53
Hide quick links:
Advertisement
Table of Contents
