Husqvarna TC 342 Operator's Manual page 17

Hide thumbs Also See for TC 342:
Table of Contents

Advertisement

PURGE TRANSMISSION
CAUTION: Never engage or disengage free-
wheel lever while the engine is run ning.
To ensure proper operation and performance, it is rec om-
mend ed that the transmission be purged before operating
tractor for the first time. This procedure will remove any
trapped air inside the transmission which may have de vel-
oped during shipping of your tractor.
IMPORTANT:
SHOULD YOUR TRANSMISSION RE QUIRE
REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD
BE PURGED AFTER REINSTALLATION BEFORE OPERATING
THE TRACTOR.
1. Place tractor safely on a level surface - that is clear
and open - with engine off and parking brake set.
2. Disengage transmission by placing freewheel control
in disengaged position. (See "TO TRANSPORT" in
this section of manual.)
3. Sitting in the tractor seat, start engine. After the en-
gine is running, move throttle control to slow position.
Dis en gage parking brake
CAUTION: At any time, during step 4, there
may be movement of the drive wheels.
4. Depress forward drive pedal to full forward position,
hold for five (5) seconds and release pedal. Depress
reverse drive pedal to full reverse position, hold for five
(5) seconds and release pedal. Repeat this procedure
three (3) times.
5. Shut- off engine and set parking brake.
6. Engage transmission by placing freewheel control
in engaged position. (See "TO TRANSPORT" in this
sec tion of manual.)
7. Sitting in the tractor seat, start engine. After the engine
is running, move throttle control to half (1/2) speed.
Disengage parking brake.
8. Drive tractor forward for approximately five feet then
backwards for five feet. Repeat this driving procedure
three times.
Your transmission is now purged and now ready for normal
op er a tion.
OPERATION
TO DUMP BAGGER (See Fig. 29)
MANUAL DUMP ONLY
Your tractor is equipped with a Dump Bag Alarm. To turn
off the alarm disengage the attachment clutch.
Position tractor in location you wish to dump bag ger.
Ensure transaxle is in the neutral position. Set parking
brake.
Raise dump handle to its highest position. Pull han-
dle forward to raise bagger and dump clippings.
To continue mowing, Ensure bag ger is down and in
proper operating po si tion which will allow mower to
operate.
17
Fig. 29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents