Detergent Dispenser - Viking FDB451 Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Detergent Dispenser

Remove outer door panel, see Outer Door Removal procedure, Page 15.
Remove connector going to detergent dispenser.
To remove detergent dispenser bend tabs up to clear and release plastic dispenser assembly
while pushing in on dispenser, this will allow the dispenser to release and come out of the inner
door liner. See arrows below, there are metal tabs on all four sides of detergent dispenser.
When replacing soap dispenser, a rubber lubricant is required to install the new dispenser,
part # 036641-000 (P80 emulsion), this should come with the new dispenser and should be
applied to seal before installation. Failure to use this lubricant could result in water leaks.
©2012 Viking Preferred Service
! WARNING
! CAUTION
Disassembly
19