Table of Contents
Advertisement
TG8011_8021BX(e).book Page 29 Monday, September 29, 2008 1:07 PM
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, w flashes even when the
handset is near the base unit), re-
register the handset.
1
Handset:
K (middle soft key) i N i
M
2
{V}/{^}: "Registration" i
M 2 times
3
{V}/{^}: Select a base unit number.
i M
L This number is used by the
handset as a reference only.
4
Base unit:
Proceed with the operation for your
model.
■ KX-TG8011/KX-TG8012
Press and hold {x} for about 5
seconds. (No registration tone)
■ KX-TG8021
Press and hold {x} for about 5
seconds, until the registration
tone sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
5
Handset:
Wait until "Enter Base PIN" is
displayed. i Enter the base unit
PIN (default: "0000"). i M
L If you forget your PIN, contact
your nearest Panasonic service
centre.
L When the handset has been
registered successfully, w stops
flashing.
Programming
Note:
L When you purchase an additional
handset, refer to the additional
handset's installation manual for
registration.
Selecting a base unit
When "Auto" is selected, the handset
automatically uses any available base
unit it is registered to. When a specific
base unit is selected, the handset makes
and receives calls using that base unit
only. If the handset is out of range of that
base unit, no calls can be made.
1
K (middle soft key) i N i
M
2
{V}/{^}: "Select Base" i M
3
{V}/{^}: Select the desired base
unit number, or "Auto". i M
L The handset starts searching for
the base unit.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored in the
base unit. This allows the handset to end
its wireless connection with the system.
1
K (middle soft key) i < i
M
2
{3}{3}{5}
3
{V}/{^}: "Deregistration" i
M
L The numbers of all handsets
registered to the base unit are
displayed.
4
Select the handset(s) you want to
cancel by pressing the desired
handset number. i M
L The selected handset number(s)
flashes.
L To cancel a selected handset
number, press the number again.
The number stops flashing.
29
Advertisement
Table of Contents
