Installing The Software From The [Scansnap Setup] Window - Fujitsu ScanSnap IX500 Operating Instructions Manual

Installing the Software from the [ScanSnap Setup] Window

Once the software is uninstalled or the installation information is removed, install the software from
the [ScanSnap Setup] window.
Install the software in the following procedure.
1.
Restart the computer.
2.
Log on as a user with Administrator privileges.
3.
If anti-virus software is running, disable the software temporarily.
ATTENTION
If you cannot disable the anti-virus software, check if the software is set to lock the application.
4.
Install the software.
For details, refer to
If you did not perform the procedure in
the software, perform the following procedures again:
l "Uninstalling the Software" (page 99)
l "Removing the Installation Information" (page 100)
l "Installing the Software from the [ScanSnap Setup] Window" (page 104)
If you still could not reinstall the software after performing the above procedures, proceed to
Software at a Time" (page
"How to Install the Software" (page
"Removing the Installation Information" (page 100)
105).
If You Have Installed the Software Before
41).
104
and then failed to install
"Installing One