Usb Devices - Panasonic CF-M34 Series Toughbook Reference Manual

USB Devices

USB Port
NOTE
The Panasonic CF-VFDU03 USB floppy disk drive can be connected via the
USB connector of either the computer or a port replicator. Before star ting up
Windows, however, only the USB connector of the computer can be used.
If a USB floppy disk drive other than the Panasonic CF-VFDU03 USB floppy disk
drive is used, operations such as reinstallation cannot be performed because the
FDD will be unable to be used as a boot drive.
Installing USB devices
1
Power off your computer
Do not shut down using the standby or hibernation function.
2
Connect the USB device to your computer
NOTE
For more detailed information, refer to the operation manual of
the USB device.
When a USB device is connected, there are cases the standby
or hibernation function will not operate in a normal manner due
to the USB device. In addition, a USB device may have to be
removed temporarily and the computer restarted in cases where
the computer is unable to start up properly.
You may need to install a driver for your USB devices. Follow the
on-screen instructions and refer to the operation manual for USB
devices on how to install the driver.
Removing USB devices
CAUTION
Do not remove a USB device while your computer is in the standby or
hibernation mode.
1
Windows 2000
Double-click
vice, then select [Stop]
Follow the on-screen instructions.
(When is not displayed or when the USB device has been removed
after the computer is turned off, this step is not necessary.)
Windows XP
Double-click
vice, then select [Stop]
Follow the on-screen instructions.
(When is not displayed or when the USB device has been removed
after the computer is turned off, this step is not necessary.)
2
Remove the USB device
( "Starting Up/Shutting Down")
on the taskbar and select the USB de-
on the taskbar and select the USB de-
31