Advertisement
Available languages
Available languages
1800121325 IS6200 US_110X154 30/05/11 15:21 Page20
may be suspended from the hook located on the hanger rod. To steam
trousers, we recommend that you also use the support with clips as in-
dicated in the illustration. (fig.14)
• Grasp the steam head with the steam vents pointing away from you.
• Start steaming by brushing material lightly with the grain of the fabric
in an up/down vertical motion. The fabric brush opens the weave of the
fabrics for better steam penetration.
• Start at the top the garment and gradually move downward (fig.13).
lways steam in a vertical position.
• For more ease, we recommend to pull the garment downward with your
free hand while steaming. Be careful not to touch the hot steam.
• During use, the hose may make a gurgling noise. This is a normal oc-
currence due to condensation. If the device begins to gurgle, rest the
steam head on its support for a few moments in order to direct the
condensation into the device once again.
CCESSORIES
Before using an accessory, check the manufacturer recommendations.
It is also recommend that you carry out a test on part of the fabric which
cannot be seen.
Fabric brush
The fabric brush opens the weave of the fabrics for better steam pene-
tration.
Be sure unit is unplugged and completely cool before attaching
accesories.
• ttach the fabric brush to the steam head by lining up
the bottom of the brush with the bottom of the steam
head. Gently push the top of the brush onto the
steam head until it clicks into place.
• Gently brush the area to be steamed with the grain or
nap of the fabric.
• Remove the fabric brush once unit is unplugged and
completely cool. Remove it by pressing on the release
tab on top of brush while pulling it forward.
20
Crease attachment
• Remove the fabric brush. Completely slide the hook
of the accessory into the slot located in the lower part
of the steam head.
• Push on the handle to open the crease attachment.
• Place the garment between the crease attachment and
steam head.
• Release the handle.
• Starting at the top of the garment, move the crease at-
tachment in a downwards motion.
• Once unit is unplugged and completely cooled down,
remove the crease attachment by sliding it off of the
steam head.
Lint pad
The lint pad is a separate accessory and cannot be attached to the steam
head.You can use the lint pad independently from the steamer.
The lint pad removes hair, lint and animal fur for a professional finish.
• To use the lint pad, slowly brush the clothing with the grain or nap of
the fabric.
• The pad can be cleaned by brushing it in the opposite direction. We re-
commend cleaning the pad on an old cloth that can be discarded.
FTER USE
• fter using the garment steamer, switch off the device by pressing the
pedal once again. The power indicator light will go off, and you can then
unplug the device.
• Hang the steam head in an upright position on the hook when not in use.
• Empty and rinse the water tank each time before storage in order to flush
out any scale particles. (fig.15)
• Loosely wind up the electrical cord and close with the Velcro strip, then
hang it from the clip on the pole. (fig.16 , 16b)
• Do not carry the steamer by the water tank handle. This appliance includes
luggage style wheels for added convenience when transporting.
Warning: Never touch the steam head until it has cooled down
completely.
21
Advertisement
