Maintenance And Care; Stain Removal - Bissell proheat 8910 series User Manual

M
aintenance and care
Machine care (continued)
4. Clean out the flow indicator filter each time it is
used to ensure best cleaning performance.
Unscrew the flow indicator cap, lift out the red
rotor and white filter. Rinse all three parts with
water. Replace the filter and rotor. Replace the flow
indicator cap. Turn until snug, do not over-tighten.
5. Any loose hair or debris can be pulled from the
brush roll if desired and thrown away.
6.
Wipe the machine's exterior with a soft cloth.
7. After carpet is dry, vacuum again to remove
hair and fuzz.

Stain removal

Do Not Delay! Attending to an accident soon after
it occurs ensures the chances for full removal.
Leaving it for an extended period of time may
cause it to set and become permanent.
1.
Blot up liquids with an absorbent cloth or paper
towels. White materials are recommended because
certain dyes may bleed and make the stain worse.
2.
Gently scrape up any semi-solids with a spoon
or spatula. Do not use a knife or other utensil
with sharp edges because it could damage the
carpet or upholstery.
3. If the area has dried, remove the remaining
semi-solids and residue with a sweeper
or vacuum.
4. Be sure to test any spot removal formulas in
an inconspicuous area first. This is important as
some dyes and materials could be damaged or
discolored by cleaning solvents. If such a change
should occur, try a different solution or call a pro-
fessional.
5. If cleaning on Berber carpeting, gently run your
machine over a hidden area. If no fuzzing occurs,
continue cleaning in soiled area.
6. Using the BISSELL Tough Stain PreCleaner, spray
evenly over soiled area. Do not overwet. Wait 3-5
minutes. Gently work the solution by blotting area
with a clean, damp, color safe cloth.
7.
Clean using either the floor cleaning or tools
setting on the ReadyTools dial.
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
15