Asus K8N-DL User Manual page 79

Access Mode [Auto] Access Mode [Auto] Access Mode [Auto]
Access Mode [Auto] Access Mode [Auto]
Allows selection of the sector addressing mode. The default [Auto] allows
automatic detection of an IDE hard disk drive. Select [CHS] for this item if
you set the Primary IDE Master to [Manual] to manually enter the drive
information. Configuration options: [CHS] [LBA] [Large] [Auto]
Manually detecting an IDE drive Manually detecting an IDE drive Manually detecting an IDE drive
Manually detecting an IDE drive Manually detecting an IDE drive
To manually enter the drive information, set the Primary IDE Master item to
[Manual], and the Access Mode item to [CHS].
Main
PIO Mode
UDMA Mode
Primary IDE Master
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
Transfer Mode
S.M.A.R.T Status
F1:Help : Select Item
ESC: Exit : Select Menu
Before attempting to configure a hard disk drive, make sure you have
the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed hard disk.
To enter the number of cylinder, head, precomp, landing zone, sector per
track for the drive, highlight an item, key-in the value that you obtained
from the drive label or documentation, then press <Enter>.
To enter a value, you may also highlight the item, then press <Enter> to
display a pop-up menu. Type in the value indicated in the drive label or
documentation, the press <Enter>.
Capacity Capacity
Capacity Capacity Capacity
Displays the auto-detected hard disk capacity.
Cylinder Cylinder Cylinder
Cylinder Cylinder
Shows the number of the hard disk cylinders.
A S U S K 8 N - D L A S U S K 8 N - D L A S U S K 8 N - D L
A S U S K 8 N - D L A S U S K 8 N - D L
Phoenix-Award BIOS CMOS Setup Utility
Primary IDE Master
[Auto]
[Auto]
[Manual]
[CHS]
None
None
-/+: Change Value
Enter: Select Sub-menu
Item Specific Help
Set a PIO mode for the
IDE device. Mode0 through
4 successive increase in
performance.
0 MB
0
0
0
0
0
Select Menu
F5: Setup Defaults
F10: Save and Exit
4 - 1 7 4 - 1 7 4 - 1 7
4 - 1 7 4 - 1 7