Mechanical Disassembly - Sanyo DP32640 Service Manual

CAUTION:
This LCD TV uses several different kinds of screws. Using
the correct screw is necessary to prevent damage. Lead
wires must be redressed to their previous locations after
servicing. The Earth sheet and gasket are provided to pre-
vent interference to other radio and television receivers.
The Earth sheet and gasket should be returned to its previ-
ous position after servicing.
STAND REMOVAL
Note: Position TV face down on a padded or cushioned
surface to protect the screen and finish.
Remove 4 screws (B: 6x16) to take the stand off.
BACK CABINET REMOVAL
1. Remove 14 screws (C:3x14, 9pcs; D:4x8, 4pcs; A:3x6, 1pc.)
shown in figure.
2. Lift the back cabinet and remove the lead wire connector.
3. Take the back cabinet off.
[ ATTENTION ]
Please do not tightet the screw (D) too strongly when
installing the back cabinet again.
POWER UNIT REMOVAL
Remove 7 screws (C:3x6) to take the power unit off.

MECHANICAL DISASSEMBLY

B
C
D
C
C
Power Unit
C
C
C
– 6 –
B
C
D
D
D
C
C
Analog Board Main(Digital) Board
C
C
C
C
C
C
C
C
C
C
C
A
C
C
C