Yamaha 50G Service Manual page 75

POWR
REMOVAL
3. Remove the throttle cable and the shift
mechanism.
1 Throttle cable joint by removing the hair pin
2 Shift rod bracket bolt
3 Shift cable joint and bushing by removing
the hair pin
4. Remove the front and rear aprons.
5. Remove the power head installation
bolts, and then remove the power head
from the upper casing.
50, 60, 70 hp ..................................8 bolts
75, 80, 90 hp ................................11 bolts
NOTE:
The power head may be difficult to separate
from the bottom cowling because of a stuck
gasket holding them together. If this is the
case, lever it off the bottom cowling with a
piece of wood. Use care not to damage the
bottom cowling or power head with the
wood.
6. Remove the dowel pins from the bot-
tom cowling or power head. To protect
the dowel pins against damage, cover
them with rags.
5-4
E