Yamaha 50G Service Manual page 108

LOWR
ASSEMBLY AND ADJUSTMENT
7. Assemble the propeller shaft.
(Except for 50GETO, C60ER, C60TR/
60FET (Oceania),
90AED, C90TR/90AET)
1) Insert the free shaft 1 into the shift
slide 2.
2) Insert the two balls 3 and shifter 4
on the shift slide.
NOTE:
Grease the balls so that they will not come
off easily from the shift slide, thus making
your work easier.
3) Align the hole in the shift slide cross
pin with the slot in the propeller
shaft cross pin and insert the shift
slide into the propeller shaft.
4) Push the shifter and stop pushing it
when the balls move into the neu-
tral groove in the propeller shaft
making a slick.
If the balls move into the reverse
groove passing the neutral, be sure
to bring them back to neutral.
5) Install the clutch dog so that its
cross pin hole is aligned with the
slot in the splined portion of the
propeller shaft.
NOTE:
Install the clutch dog so that the "F" mark on
the clutch dog is on the forward gear side.
6) Bring the cross pin hole in the
clutch dog with the hole in the shift
slide and insert the cross pin into
these holes. Then, install the cross
pin ring.
7) Place the shift cam on the shifter
(with the "F" mark on the shift cam
facing forward) and insert the pro-
peller shaft into the forward gear.
6-15
E
C75TR, 90AEHD,