BRKT
BRACKET UNIT
K20002-0
REMOVAL
1. Remove the power-head.
2. Remove the swivel-bracket from the
upper casing.
CAUTION:
Lay the outboard motor on the floor to
carry out this removal.
DISASSEMBLY
1. Referring to the exploded diagram, dis-
assemble the bracket unit.
INSPECTION
ANODE
1. Check anode and replace with new one
when the size is less than 1/3 of original
length.
BRACKET
1. Inspect the bracket and replace them, if
cracked.
TRIM SENSOR
1. Check resistance of the new trim
sensor.
Trim sensor resistance:
Pink – Black
360 ~ 540 Ω
Black – Orange
800 ~ 1200 Ω
2. Measure resistance between black and
pink leads to check that the value
changes gradually in the whole trim
and tilt range. If not, replace trim sensor
with new one.
7-9
E