Resetting The Top Of Form To The Standard Setting; Setting The Printhead Gap - Oki ML3320 User Manual

R
ESETTING THE TOP OF FORM TO THE STANDARD SETTING
1. Turn the printer off.
2. Hold PARK + QUIET/TOF while turning the printer back on.
Switching paper paths
To switch from continuous-forms to single-sheet feed:
1. Tear off any printed pages.
2. Press PARK.
3. Move the paper separator to the single-sheet feed position.
4. Place the wire feed guide in the paper separator.
5. Move the paper lever to the position marked "TOP."
6. Place a sheet of paper in the paper separator.
To switch from single-sheet feed to continuous forms:
1. Press FF/LOAD to remove the single-sheet paper.
2. Lower the paper separator into the continuous-forms position and swing the wire
feed guide over onto the pull-up roller.
3. Move the paper lever to the position marked "REAR" or "BOT," as appropriate.
4. Load continuous-form paper, then press FF/LOAD.
S
ETTING THE PRINTHEAD GAP
The printhead gap is the distance between the printhead and the platen. To adjust the gap,
open the access cover and move the blue lever (1) to the recommended setting from the
table below.
NOTE
It is recommended that the printer be switched off prior to removing the
access cover.
1
Loading paper > 20