Table of Contents
Advertisement
R
EAR VIEW
5
6
1.
Optional connector position: connect to optional accessory serial interface card or
100Base-TX/10Base-T network card.
2.
Cut-sheet feeder/ Roll Paper stand connector: connect the optional cut-sheet feeder
or the roll paper stand.
3.
Parallel connector: connect to parallel interface connector.
4.
USB connector: connect to USB interface cable.
5.
Pin Tractor: to load and feed continuous forms.
6.
Power connector: connect to printer power cable.
L
OCATING YOUR PRINTER
>
Select a firm solid surface on which to site your printer.
>
Allow enough space around your printer (e.g. at least 60cm from any wall) for easy
access to the platen knob and the various paper feed paths.
>
Make sure a grounded power outlet is available nearby.
P
OWERING ON YOUR PRINTER
Operations of this equipment are not warranted when the
equipment is connected to UPS (Uninterruptible Power Supply)
and/or inverter. Doing so may result in damage of this equipment.
Do not use an UPS and/or inverter.
1.
Ensure that your printer power switch is set to OFF.
2.
Connect the power cable connector (1) to the A/C Input (2) on the printer.
WARNING!
Getting started > 10
1
2
3
4
Hide quick links:
Advertisement
Table of Contents
