Sony CMT-HP8V Operating Instructions Manual page 7

3 Connect the video input jack of your TV
to the VIDEO OUT jack with the
supplied video cord.
When using a TV
Turn on the TV and select the video input so you can
view the pictures from this system.
4 For models with a voltage selector, set
VOLTAGE SELECTOR to the local
power line voltage.
Refer to the print on your system's
VOLTAGE SELECTOR for available
settings.
* Saudi Arabian model: 120 – 127 V
5 Connect the power cord to a wall
outlet.
The demonstration appears in the display.
When you press ?/1, the system turns on
and the demonstration automatically ends.
If the plug does not fit the wall socket,
detach the supplied plug adaptor (only for
models equipped with an adaptor).
6 Set the color system to PAL or NTSC
depending on the color system of your
TV while the power is off.
The color system Do this
of your TV
Press ?/1 while holding
AUTO
down X. If your TV
(factory setting)
automatically changes the
color system according to
the input signal, the system
is set to AUTO.
NTSC Press ?/1 while holding
down >. The system is
set to NTSC.
Press ?/1 while holding
PAL
down .. The system is
set to PAL.
Notes
• You cannot set the color system in Power Saving
Mode.
• When you play back a VIDEO CD recorded in a
different color system from the one you set to the
unit, the picture image may be distorted.
Inserting two R6 (size AA)
batteries into the remote
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
continued
GB
7