Starter Switch Positions; Smartkey - Mercedes-Benz 2010 R-Class Operator's Manual

251_AKB; 4; 52, en-US
d2ureepe,
the door-mounted remote tailgate switch.
Monitor the closing procedure carefully to
make sure no one is in danger of being
injured.
To interrupt the closing procedure, press or
pull the door-mounted remote tailgate switch.
If the tailgate comes into contact with an
object while closing, the closing procedure is
stopped and the tailgate reopens. This may
happen if luggage has been piled too high, for
example.
X
Turn the SmartKey in the starter switch to
position 1 or 2.
X
Press remote tailgate opening/closing
switch : until the tailgate begins to close.
While the tailgate is closing an acoustic
warning sounds.
X
Interrupting the closing procedure:
Press or pull remote tailgate opening/
closing switch :.
Limiting opening height of tailgate
You can limit the opening height of the
tailgate in the upper opening range. This can
be useful, for example, when the space above
the tailgate is not sufficient.
Activating
X
Open the tailgate: Pull on handle
( Y page 75) or press and hold button
F on the SmartKey until the tailgate
opens.
X
Stop opening procedure: When the
tailgate is in the desired position, press
tailgate closing switch (
on handle once more.
X
You can also press or pull the remote
tailgate opening/closing switch
( Y page 78) to stop the opening procedure.
X
Press and hold the tailgate closing switch
in the tailgate (
short acoustic signal.
The opening height of the tailgate is limited.
The tailgate will now stop at the stored
position when opened.
Deactivating
X
Press and hold the tailgate closing switch
in the tailgate (
two short, consecutive acoustic signals.

Starter switch positions

SmartKey

G
Starter switch
g
1
2
3
When you switch on the ignition, all lamps
Y page 77) or pull
(except low-beam headlamp indicator lamp,
high-beam headlamp indicator lamp, and turn
signal indicator lamps unless activated) in the
instrument cluster come on. If a lamp in the
instrument cluster fails to come on when the
ignition is switched on, have it checked and
replaced if necessary. If a lamp in the
instrument cluster remains on after starting
the engine or comes on while driving, refer to
"Lamps in instrument cluster" (
2009-03-23T09:22:52+01:00 - Seite 79
Version: 2.11.8.1
Starter switch positions
Y page 77) until you hear a
Y page 77) until you hear
Observe Safety notes, see page 55.
For removing SmartKey
Power supply for some electrical
consumers, e.g. radio
Ignition (power supply for all electrical
consumers) and driving position
Starting position
79
Y page 299).
Z