Locator Lighting - Mercedes-Benz 2010 E-Class Coupe Operator's Manual

Control system
124
In low ambient light conditions the following
lamps will come on additionally:
Low-beam headlamps
R
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
R
For more information on the daytime running
lamp mode, see (
i Make sure the exterior lamp switch is set
to M or c when you switch off the
daytime running lamps while driving at
night.
For safety reasons, resetting all the functions
of all submenus to the factory settings while
driving ( Y page 121) will not deactivate the
daytime running lamp mode.
The following message appears in the
multifunction display:
Cannot Be Completely Reset to
Factory Settings while Driving..
Switching Adaptive Highbeam Assist on
or off
X
Press button = or ; to select the
Sett. menu.
X
Press button : or 9 to select the
Lights submenu.
X
Press button a.
X
Press button : or 9 to select the
Adaptive Highbeam Assist: function.
The current setting Enabled or Disabled
is shown.
Y
page 89).
X
Press button a to change the current
status.
Depending on the previous status, the
Adaptive Highbeam Assist: function
will be Enabled or Disabled.
For more information on the Adaptive
Highbeam Assist, see (
Switching locator lighting on or off
With the Locator Lighting: function
activated and the exterior lamp switch in
position c
the exterior lamps will come on during
R
darkness when the vehicle is unlocked with
the SmartKey.
The lamps will go out when the driver's door
is opened.
If you do not open the driver's door after
unlocking the vehicle with the SmartKey,
the lamps will go out automatically after
approximately 40 seconds.
the exterior lamps will remain on for
R
15 seconds during darkness after exiting
the vehicle and closing all doors.
If, after turning off the engine, you do not
open or close a door, the lamps will
automatically go out after 60 seconds.
The following lamps will come on
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
R
Front fog lamps
R
X
Press button = or ; to select the
Sett. menu.
X
Press button : or 9 to select the
Lights submenu.
X
Press button a.
X
Press button : or 9 to select the
Locator Lighting: function.
The current setting Enabled or Disabled
is shown.
Y page 91).