Razor dirt rocket MX350 Owner's Manual page 5

asseMBly anD seT-up
q Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of
manufacturing and your purchase.
Using a bicycle-style tire pump equipped for a Schrader-type valve, inflate both tires to the PSI indicated on
the sidewall of the tire.
q charging the Battery
Your electric motorbike may not have a fully charged battery; you must charge the battery prior to use.
• Initial charge time: 18 hours
• Recharge time: up to 12 hours,
depending on the level of depletion
Charger
Port
Charger
Plug
need Help? Visit our web site for replacement parts, product support and a list of authorized service
centers at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time.
• Run time: Up to 30 minutes of continuous ride time
• Average battery life: 250 charge/discharge cycles
1
Turn power OFF before
charging. Plug the charger into
the charger port on the motor
bike.
2
Plug the charger into a wall
outlet. If the lights on charger
do not light up, check the
power to the outlet. If neces-
sary, try a different outlet.
4
Note: The pressurized air
supplies found at gasoline
stations are designed to inflate
high-volume automobile tires.
If you decide to use such an
air supply to inflate your tires,
first make sure the pressure
gauge is working, then use very
short bursts to inflate to the
correct PSI. If you inadvertently
over-inflate the tire, release the
excess pressure immediately.
warnIng:
Always disconnect your electric
motorbike from the charger
before cleaning with liquid.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status.
Refer to the illustration on
the charger unit for the actual
"charging" and "charged"
status indications for your
model charger.
Chargers have built-in over-
charge protection to prevent
battery from being over-
charged.
Charger will get warm during
use. This is normal for some
chargers and is no cause for
concern. If your charger does
not get warm during use, it does
not mean that it is not working
properly.
Be sure to properly align the
groove on the charger input
plug with the corresponding
socket on the case;
otherwise, no charging
action will occur.