Razor MX350 DIRT ROCKET Installation Instructions Manual

Tools Required:
A. Phillips head screwdriver
B. 2.5mm Allen wrench
C. 5mm Allen wrench
D. 10mm open wrench
F. Flat head screwdriver
CAUTION: To avoid potential shock or other injury, turn power switch OFF and discon-
nect charger before attempting these procedures. Failure to follow these steps in the correct
order may cause irreparable damage.
Step 1
Remove the two hex bolts under the seat using a
5mm Allen wrench and hold the nuts in the back
using a 10mm open wrench
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
( )
Not included
Figure 1
THROTTLE INSTALLATION INSTRUCTIONS
Step 2
Slide the fairing towards the back of the bike
and remove.
MX350 DIRT ROCKET™
Figure 2
1