High-Mounted Brake Lamp - Mercedes-Benz 2009 CL-Class Operator's Manual

Practical hints
Replacing bulbs
Front lamps
Lamp
1 Low- and high-beam
9
lamp
2 High-beam flasher lamp H11 (55 W)
IR emitter (for Night
View Assist)
3 Additional turn signal
lamp
4 Side marker lamp
5 Parking and standing
lamp
6 Turn signal lamp
7 Corner-illuminating
lamp
8 Front fog lamp
Vehicles with Bi-Xenon headlamps: Low beam and high beam use the same D1S-35 W lamp. Do not replace the Bi-Xenon bulbs yourself. Contact an authorized
9
Mercedes-Benz Center.
544
Rear lamps
Type Lamp
D1S-35 W 9 High-mounted brake
lamp
a Brake lamp, tail lamp,
parking and standing
H11 (55 W)
lamp
b Turn signal lamp
LED
c License plate lamps
W 5 W d Rear fog lamp (driver's
side only)
W 5 W
e Backup lamp
PY 24 W
f Side marker lamp
H7 (55 W)
Notes on bulb replacement
Only use 12-volt bulbs of the same type and
R
H11 (55 W)
with the specified watt rating.
Switch the lights off before changing a bulb
R
to prevent short circuits.
Always use a clean lint-free cloth when
R
handling bulbs.
Your hands should be dry and free of oil and
R
grease.
Type
If the newly installed bulb does not come
R
on, contact an authorized Mercedes-Benz
LED
Center.
i Mercedes-Benz recommends using
LED
Longlife (LL) bulbs.
! Do not replace LEDs and bulbs yourself.
HiP
You could otherwise damage the LEDs, the
bulbs or parts of the vehicle. Only have the
W 5 W
LEDs and bulbs replaced at an authorized
HiP Mercedes-Benz Center.
Replacing bulbs for front lamps
HiP
G Warning!
LED
Do not remove the cover for the Bi-Xenon
headlamp. Because of high voltage in
Xenon lamps, it is dangerous to replace the
bulb or repair the lamp and its components.
It is recommended to have such work done
by a qualified technician.
i Replacing the bulbs for the front lamps is
a technically complex process. Have such