Mercedes-Benz 2009 C-Class Operator's Manual page 360

Practical hints
Replacing bulbs
Front turn signal lamp bulb
Mark
1
Handle
2
Bulb socket
3
X
Turn bulb socket with handle
3
counterclockwise and remove it.
X
Pull bulb out of bulb socket 3.
X
Gently press the new bulb into bulb socket
until the bulb engages.
3
X
Place bulb socket back into the housing.
3
Handle must be in a horizontal line and
2
mark must be on the upper part (driver's
1
358
side headlamp) or lower part (passenger-
side headlamp).
X
Turn bulb socket
engages.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following:
X
Switch off the ignition.
X
Turn the exterior lamp switch to position
M.
X
Open the trunk.
Tail lamp unit
2
X
Driver's side: Lift up the bottom and pull out
the trim panel covering the driver side rear
light.
X
Passenger side: Open the fuse box in the
trunk ( Y page 373).
clockwise until it
3
1
2
X
X
X
Tabs
Connector
Disconnect electrical connector 2.
Pull tabs in direction of arrows.
1
Remove the bulb carrier.