Synchronizing - Mercedes-Benz 2009 C-Class Operator's Manual

Controls in detail
Panorama roof with power tilt/sliding panel
compartment. To reduce or eliminate these
noises, change the position of the tilt/
sliding panel or open a window slightly.
Raising
X
Raising manually: Press and hold the roof
panel switch to the resistance point in
direction of arrow 1.
X
Release the roof panel switch when the
desired position is reached.
X
Express operation: To raise the tilt/
sliding panel completely, press the roof
panel switch past the resistance point in
direction of arrow and release.
1
X
Stopping during express operation:
Move the roof panel switch in any direction.
i
Express raising is not available when the
tilt/sliding panel is open. The tilt/sliding
panel must be closed first.
Closing
X
Closing manually: Pull and hold the roof
panel switch to the resistance point in
direction of arrow 3.
X
Release the roof panel switch when the
desired position is reached.
228
X
Express operation: To close the tilt/
sliding panel completely, pull the roof panel
switch past the resistance point in
direction of arrow and release.
3
X
Stopping during express operation:
Move the roof panel switch in any direction.
Closing when the tilt/sliding panel is
blocked
G Warning!
Make sure that nobody can become
trapped and be seriously or even fatally
injured when closing the tilt/sliding panel
without automatic reversal function.
If the movement of the tilt/sliding panel is
blocked during the closing procedure (e. g. by
ice or pollution), the tilt/sliding panel will stop
and open slightly.
X
Immediately after the tilt/sliding panel has
stopped because it was blocked, pull the
roof panel switch in direction of arrow
until the tilt/sliding panel is fully closed.
If the tilt/sliding panel is blocked again and
opens slightly:
X
Immediately after the tilt/sliding panel was
blocked, pull the roof panel switch in
direction of arrow
3
panel is fully closed.
G Warning!
Pulling and holding the roof panel switch to
close the tilt/sliding panel immediately
after it had been blocked two times will
cause the tilt/sliding panel to close without
any reversal function for as long as you hold
the roof panel switch.

Synchronizing

The tilt/sliding panel and front roller
sunblinds must be synchronized after a
malfunction or if the tilt/sliding panel does
not open smoothly.
! Do not attempt to open the tilt/sliding
panel before the tilt/sliding panel is
properly synchronized. The tilt/sliding
panel could otherwise lock-up in the open
position.
3
If the tilt/sliding panel cannot be closed or
synchronized, contact an authorized
Mercedes-Benz Center or call Roadside
Assistance.
until the tilt/sliding