Canon Pixma MP530 User Manual page 178

Unpack the machine
Please confirm bundled thing by the illustration printed on the flapped lid of the packing box.
QT5-0214-V01
1
Prepare the machine
2
Install the Print Head
Electrical Contacts Protective Cap
o
Lower the Print Head Lock Lever
carefully and press it down.
A
CAUTION
There might be some transparent or light blue ink on
the inside of the bag the print head comes in - this has
no effect on print quality. Be careful not to get ink on
yourself when handling these items.
• Firmly raise the Print Head Lock Lever
until it stops.
fJ
Remove the orange protective cap
from the Print Head and discard it.
@P
Do not touch the Print Head nozzles and the electrical
contacts.
e
Insert the Print Head.
o
Remove the Print Head from its
package.
Paper Output Tray Open Button
Scanning Unit (Printer Cover)
A
IMPORTANT
Be careful not to touch the buttons on the Operation
Panel.
fj
Open the Inner Cover. Write down
the serial number located inside the
machine. You will need this to register
your products.
o
Open the Scanning Unit (Printer Cover)
until it locks into place. The Print Head
Holder moves to the center.
o
Press the Open button to open the
Paper Output Tray. Open up and set
the Paper Output Tray extension by
pressing down the hollow on its front
side.
Telephone
line
Telephone
line
• Built-in computer modem and telephone
(Telephone]
~=
External device jack
[]=
Telephone line jack
.Telephone or answering machine
A
IMPORTANT
Be sure to use the bundled telephone line cable.
~onnect
the
telepho~e
S ..
===="=====:::::-
lme cord to the wall]ack. . . .
You can connect an external device
(telephone or answering machine) if necessary.
Connect external devices as follows:
fJ
Connect the telephone line and any
necessary external device.
• Plug the power cord into the back of
the machine and connect the other
end to a power outlet. Press [ON/OFF].
o
Remove the shipping tape from the
machine.
A
IMPORTANT
Make sure to remove the protective film from the
Feeder Cover.
e
Use [ ~] or [~ ] on the Operation
Panel to select the language for the
LCD, then press [OK].
A
IMPORTANT
If the Scanning Unit (Printer Cover) is left open for
more than 10 minutes, the Print Head Holder moves to
the right. Close and reopen the Scanning Unit (Printer
Cover) to return the Holder to the center.
If the message <SET INK CARTRIDGE>
appears, go to
0.