Entering A Stopover - Mercedes-Benz 2007 CL 550 Operator's Manual

Moving the map and selecting the des-
tination
Moving map: Slide qmr,
wmx.
Adjusting map scale: Rotate ymz.
Rotating clockwise enlarges the map,
rotating counterclockwise reduces it.
Selecting a destination: Press n.
If the crosshair is located off the edge
omp
or of the digital map, a route cannot be
calculated to this destination and you
will see the message "The destination is
located off the map.".
Select "OK".
Move the map and select a destination
again.
If the destination is within the limits of
the digital map, COMAND attempts to
attribute the destination to the map,
which can take approximately
2 seconds.
If the destination can be attributed, you
will see the address of the destination.
If not, you will see the display "Destina-
tion from map".
Starting route calculation:
Select "Start", see also ( page 181).
COMAND navigation system (entering a destination)

Entering a stopover

i
ter a stopover. Stopovers can be predefined des-
tinations from the following predefined
categories:
However, you can also enter destinations other
than the predefined ones.
i
ence the route guidance calculation to the main
destination. When you have reached your stop-
over, COMAND automatically calculates the
route to the main destination.
Control systems
When route guidance is active, you can en-
"Mercedes-Benz Center"
"Hospital"
"Gas station"
"Parking lot"
"Restaurant"
You can use the stopover function to influ-
185