Mercedes-Benz 2005 M-Class Operator's Manual page 208

Operation
Driving instructions
Tires
Check the tread depth and maintain
specified tire pressure (see tire pres-
sure label inside the fuel filler flap).
Check tires for possible damage and
remove foreign objects.
Replace missing valve caps.
Rims
Dented or bent rims can cause tire
pressure loss and damage the tire
beads. For this reason, check and, if
necessary, change rims before driving
off-road.
Vehicle tool kit
Check if the vehicle jack is functional.
In all cases take the vehicle tool kit, a
strong tow rope, a shovel and a small
plank (to put under the vehicle jack on
sandy soil) with you.
206
Driving in steep terrain
Slope angle
1 25°
2 26°
Switch to LOW RANGE mode before
starting to drive up or down steep in-
clines ( page 127).
Driving on embankments, slopes and
other steep inclines should only be
done straight up or downhill, i.e. in the
line of gravity. Maximum vehicle climb-
ing ability is a 60% grade.
Do not drive along the side of a slope
(danger of vehicle rollover). If in doing
so the vehicle begins to show a tenden-
cy to roll, immediately steer into a line
of gravity (straight up or downhill).
To help avoid the vehicle rolling over,
never turn it around on steep inclines.
If the vehicle cannot complete the at-
tempted climb, back it down in reverse
gear.
Utilize the engine's braking power
when descending a slope, observe the
engine speed (do not overrev the en-
gine). Apply the service brake as need-
ed.
Check the brakes after a lengthy down-
grade drive.
i
Avoid excessive engine speeds – drive
with moderate engine speeds
(max. 3000 RPM).
Select gear range 2 or 1 on the auto-
matic transmission ( page 122).