Table of Contents
Advertisement
Power Supply Adjustment Auto Item Feed
Note: This mode is available to perform the temperature correction and
power supply adjustment without entering the manual mode.
• Setting method of power supply adjustment auto item feed mode.
1. Set the test mode (see page 13)
2. Press the
key to activate the overall adjustment mode.
.
Set LCD display
000
A s s y * *
[VOL --]
3. Press the
key to set the temperature correction mode.
Set LCD display
015
# # # S * *
** : Adjusted value
4. To change the initial value adjust with the
key.
Press the
key to write the adjusted value, and the
ENT/u
item number increases automatically.
When not writing the adjusted value, press the
to the next item.
Set LCD display
741
A D * *
** : Adjusted value
• Configuration of power supply adjustment auto item feed
.
key
key
.
key
.
key
.
key
.
key
.
[VOL +]
[VOL --]
or
key to move
>
000Assy **
VOL – key
015 ###S**
key
>
741 AD **
key
>
742 AD **
key
>
743 AD **
>
key
744 AD **
>
key
745 AD **
>
key
5. Connect a digital voltmeter to the measuring points on the
MAIN board, and adjust the voltage with the
--]
key. (see page 18 to 21)
Press the
key to write the adjusted value, and the item
ENT/u
number increases automatically.
6. When not writing the adjusted value, press the
move to the next item. The
last item.
7. The following message is displayed after all power supply
adjustments finish.
Set LCD display
000
A D J O K
8. Press the x/CANCEL key to return the test mode (display
check mode).
747 AD **
key
.
748 AD **
key
.
749 AD **
.
key
751 AD **
.
key
752 AD **
.
key
753 AD **
>
000 ADJ OK
MZ-NE410/NE410CK
[VOL +]
or
key to
>
key is available to back to the
.
>
key
>
key
>
key
key
>
key
>
key
[VOL
23
Advertisement
Table of Contents
