Table of Contents
Advertisement
Controls in detail
Control system
With daytime running lamp mode se-
lected and the exterior lamp switch at
position 0, the following lamps will
come on automatically when the en-
gine is turned on:
Parking lamps and low beam head-
lamps
License plate lamps (in low ambient
light conditions)
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
submenu to factory settings
Lighting
( page 140) while driving will not re-
set the daytime running lamp mode.
In the display you will then see the mes-
sage:
Lighting – Cannot be com-
pletely reset to factory settings
.
while driving
146
Setting locator lighting
During darkness, the following lamps will
come on when the exterior lamp switch is
in position U, the locator lighting fea-
ture is activated, and the vehicle is un-
locked with the SmartKey:
Parking lamps
Tail lamps
License plate lamps
Front fog lamps
To activate locator lighting:
Make sure the function surround light-
ing is set to
on
, see ( page 146).
Turn the exterior lamp switch to posi-
tion U.
The locator lighting switches off when the
driver's door is opened. It switches off au-
tomatically after a period of approximately
40 seconds.
Move the selection marker with
the æ or ç button to the
submenu.
ning
Press button j or k repeatedly
until you see this message in the dis-
play:
Function Surround lighting
The selection marker is on the current
setting.
Press æ or ç to select the de-
sired setting.
The locator lighting will be switched on
or off.
Light-
.
Advertisement
Table of Contents
