Table of Contents
Advertisement
Controls in detail
Control system
The selection marker is on the current
setting.
Press æ or ç to select the de-
sired setting.
Turn the exterior lamp switch to posi-
tion U.
The locator lighting will be switched on
or off.
Ambient light level
Using this function, you can adjust the
brightness of the ambient lighting.
Move the selection marker with the
æ or ç button to the
submenu.
140
Press button j or k, repeatedly
until you see the message
light Level
in the display
The selection marker is on the current
setting.
Press æ or ç to select the
brightness of the lighting.
the darkest setting and
the brightest setting.
The ambient light is switched off below
setting
or above setting
1
tion marker points to
Lighting
Setting night security illumination (Exte-
rior lamps delayed switch-off)
Use the
Headlamps delayed shut-off
function to set whether and for how long
you would like the exterior lamps to illumi-
nate during darkness after all doors are
closed. When the delayed switch-off fea-
Ambient
ture is activated, the following lamps will
.
remain lit after you remove the key from
the starter switch:
Parking lamps
Tail lamps
1
represents
License plate lamps
5
represents
Front fog lamps
The exterior lamp switch must be set to po-
sition U ( page 112).
. The selec-
5
.
off
i
You can reactivate this function within
ten minutes by opening a door.
If you do not open a door after remov-
ing the key, the lamps will automatical-
ly switch off after 60 seconds.
Advertisement
Table of Contents
