Cisco 7925G Neighbor List; Cisco 7925G Site Survey - Cisco 7925G Deployment Manual

Cisco 7925G Neighbor List

The Cisco Unified Wireless IP Phone 7925G can be utilized to verify coverage by using the Neighbor List menu.
By Default, the Cisco Unified Wireless IP Phone 7925G only scans when the current signal lowers to a certain threshold, so you
may see only one access point in the list if configured for auto scan mode.
To see all access points in the neighbor list menu, place a call from the Cisco Unified Wireless IP Phone 7925G to a wired IP
phone, where scanning occurs constantly while the phone call is active in auto scan mode.
Otherwise configure continuous scan mode.
The connected access point will be highlighted in red.
Access the neighbor list menu on the phone by pressing Settings > Status > Neighbor List

Cisco 7925G Site Survey

The Cisco Unified Wireless IP Phone 7925G also has a Site Survey application, which is an offline mode that gathers
information about the access points for the configured network profile and generates and HTML report after exiting the
application.
This information can be utilized to confirm access point configuration as well as coverage.
The neighbor table shows which access points (along the column) are neighbors of the access points with the strongest signal
listed in the row. The percentage of time that the access point had the highest RSSI is displayed as well as the RSSI range for
that access point when it was observed. The access point name is hyperlinked to the access point detail listed below.
Cisco Unified Wireless IP Phone 7925G Deployment Guide 36