Tools Needed - Black Max BM801700 Operator's Manual

WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.

TOOLS NEEDED

See Figure 4.
The following tool (not included or drawn to scale) is needed
for assembly:
 Screwdriver
INSTALLING THE WHEELS
See Figure 5.
 Locate the axles, hitch pins, washers, and wheels.
 Slide the axle through the hole in the center of the wheel.
 Slide a washer onto the axle, then lift the machine and
slide the axle into the wheel mounting hole in the machine
base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
ASSEMBLY
INSTALLING THE HANDLE
See Figure 6.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
Push and hold the push-pin button on the side of the handle
as you slide the handle onto the frame.
NOTE: Before use, pull the handle up until the lock button
snaps through the locking slots to secure the handle in place.
ATTACHING THE TRIGGER HANDLE STORAGE
BRACKET/NOZZLE STORAGE PANEL
See Figure 7.
 Place the trigger handle storage bracket/nozzle storage
panel over the holes in the frame.
 Insert a screw through each of the holes and tighten
securely.
INSTALLING THE SPRAY WAND
See Figure 8.
 Push the end of the spray wand into the trigger handle
and rotate clockwise to secure.
 Place the assembled spray wand in the trigger handle
storage bracket.
 Pull on the spray wand to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 9.
 Screw the collar on the high pressure hose into the trigger
handle inlet coupler by turning the hose collar clockwise.
Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.
 Pull on the hose to be certain it is properly secured.
Page 10 — English