Table of Contents
Advertisement
CHECKING THE CODES
If you have set up the One For All 4-Device Video Expert
Plus With Learning remote control using the Searching
For Your Code procedure, you may need to find out which
four-digit code is operating your equipment. For example,
to find out which code is operating your TV:
1.
Turn on your TV.Set it to the TV mode.
2.
On the remote control, press and hold SET until
the LED blinks twice, then release SET.
3.
Enter 9 - 9 - 0. The LED will blink twice.
4.
To view the code for the first digit, press 1 once.
Count the number of LED blinks (e.g., 3 blinks
= 3) and write down the number in the left-
most TV Code box below.
NOTE: If a code digit is "0", the LED will not blink.
5.
Repeat step 4 three more times for remaining
digits. Use 2 for the second digit, 3 for the third
digit, and 4 for the fourth digit. Finish writing
down the code in the TV Code boxes below.
6.
To check for the codes of your other compo-
nents, repeat steps 1 through 5, but substitute
the appropriate key (i.e., DVD, VCR, or CBL/SAT)
for the (DVD/LD,VCR, or Cable/Satellite) com-
ponent you are checking.Write down the codes
in the appropriate boxes below.
TV Code
DVD (or LD) Code
VCR Code
Cable/Satellite Code
24
PROGRAMMING THE MASTER POWER KEY
FOR ALL ON/OFF
With the One For All 4-Device Video Expert Plus With
Learning, you can program the M. POWER key to turn
your TV,VCR, DVD (or LD), and Cable (or Satellite)
components on and off with the press of one button.
1.
On the remote control, press and hold SET
until the LED blinks twice, then release SET.
2.
Enter 9 - 9 - 5. The LED will blink twice.
3.
Press M.POWER once.
4.
Enter the following sequence*:
a. Press TV once.
b. Press VCR once.
c. Press DVD once.
d. Press CBL/SAT once.
5.
Press and hold SET until the LED blinks twice,
then release SET.
Now, when you press M.POWER once, the
6.
remote control will direct power to your TV,
VCR, DVD (or LD) player, and Cable/Satellite
component and leave the remote control in the
TV mode.
* NOTE: If you do not want all of your equipment to power up
all of the time, you can shorten step 4 to include only those
devices you want to turn on or off. For example, to just power
up your TV and DVD (or LD) player, enter the following
sequence for step 4:
a. Press
TV once.
b. Press DVD once.
Now when you press M.POWER once, the One For All 4-Device
Video Expert Plus remote control will only direct power to
your DVD (or LD) player and TV, and still leave the remote
control in the TV mode.
25
Hide quick links:
Advertisement
Table of Contents
