Setup Codes For Satellite Receivers; Programming Dvd Player Control - One for All URC 4880 User Manual

PROGRAMMING CABLE CONVERTER OR
SATELLITE RECEIVER CONTROL
Setup Codes for Cable Converters (Continued):
Samsung 0144, 0040
Scientific Atlanta 0008, 0477, 0017, 0877
Signal 0015, 0040
Signature 0011
Sprucer 0021
Starcom 0003, 0015
Stargate 0015, 0040, 0797
Starquest 0015
TV86 0063
Tandy 0258
Teleview 0040
Timeless 0418
Tocom 0012, 0013
Toshiba 0000
Tusa 0015
Unika 0153, 0022
United Artists 0007
Universal 0153, 0022, 0056, 0191
Viewstar 0063, 0258
Zenith 0000, 0525, 0899
Zentek 0400

Setup Codes for Satellite Receivers:

AlphaStar 0772
Echostar 0775, 1005
Expressvu 0775
General Instrument 0627, 0361, 0869
HTS 0775
Hitachi 0819
Hughes Network 0749
JVC 0775
Jerrold 0627, 0361
Magnavox 0724, 0722
Memorex 0724
Next Level 0869
Panasonic 0701
Philips 0724, 0722
Primestar 0627, 0361
RCA 0566, 0143, 0392, 0855
Radio Shack 0869
Sony 0639
Star Choice 0869
Toshiba 0790
Uniden 0724, 0722
Zenith 0856
20
continued on next page...

PROGRAMMING DVD PLAYER CONTROL

Locate the brand name of your DVD (or LD) player in the
Setup Codes For DVDs (or LDs) section on the next page,
and write it in the following space.
DVD (or LD) Brand: __________________________
The brands are listed in alphabetical order with the most
popular codes listed first.You will use one of these codes to
program the One For All 4-Device Video Expert Plus With
Learning remote control to operate your DVD (or LD) player:
1.
2.
3.
4.
5.
NOTE: Remember, to use the One For All 4-Device Video Expert Plus
With Learning remote control to operate your
press DVD first.
Turn on your DVD (or LD) player.
On the remote control, press DVD once.
Press and hold SET until the LED blinks twice,
then release SET.
Enter the first four-digit code for your DVD (or
LD) player. If you perform this procedure cor-
rectly, the LED will blink twice.
NOTE: If the LED did not blink twice after entering
the code's last digit, then repeat steps 2 through 3 and
try entering the same code again.
Aim the remote control at your DVD (or LD)
player and press POWER once. The unit should
turn off. If your DVD (or LD) player remote
control does not have a POWER key, press
PLAY. If the DVD (or LD) player does not
respond, repeat steps 2-3, trying each code list-
ed for your brand until you find one that works.
If the DVD (or LD) player still does not work ,
try searching for the code (see Searching For
Your Code on page 23).
Write your DVD (or LD) player code in the
boxes below for future reference.
DVD (or LD) player
21
,