Setting Audio Output - Memorex MVD2256 Owner's Manual

Setting audio output

NOTE:
Do not set to DIGITAL when you connect the unit to an amplifier without any built-in decoder such as a Dolby
•
Digital using the optical or coaxial digital cable.
Otherwise it may cause such a high level noise that it may be harmful to your ears and damage your speakers.
• When you set to DIGITAL, sound is not output from the analogue AUDIO OUT(L, R) jacks and the speakers on
the unit. Any 96kHz Sampling rate digital audio will be output through the analogue outputs only, not the digital
outputs.
MPEG Audio will be output with 2 channel digital audio when you set to DIGITAL.
•
• DTS Audio will be output to COAXIAL or OPTICAL even if you set to ANALOGUE.
44
1
Press SET UP in the stop mode.
2
Press UP or DOWN to select
AUDIO OUTPUT, then press
SELECT.
3
Press UP or DOWN to select
DIGITAL or ANALOGUE, then
press SELECT.
DIGITAL:
When the unit is connected to an amplifier with any built-in de-
coder among Dolby Digital or MPEG or DTS.
ANALOGUE
•
When the unit is connected to an amplifier without any built-in
decoder among Dolby Digital or MPEG or DTS.
•
When the unit is connected with RF cable to the TV.
4
To make SET UP screen disappear, press RETURN while the
SET UP screen is being displayed.
1) RATING LEVEL
2) AUDIO
3) SUBTITLE
4) TV SCREEN
5) OSD DISPLAY
6) MENU LANGUAGE
7) AUDIO OUTPUT
8) SETUP LANGUAGE
PRESS RETURN TO EXIT
AUDIO OUTPUT
DIGITAL
ANALOGUE
PRESS RETURN TO EXIT