Chevrolet 2011 HHR Owner's Manual page 352

When rotating the vehicle's tires, always use the
correct rotation pattern shown here.
Do not include the compact spare tire in the tire
rotation.
After the tires have been rotated, adjust the front
and rear inflation pressures as shown on the Tire
and Loading Information label. See Inflation - Tire
Pressure on page 6 57 and Loading the Vehicle on
page 5 23.
Reset the Tire Pressure Monitor System. See Tire
Pressure Monitor Operation on page 6 59.
6-64
Make certain that all wheel nuts are properly
tightened. See Wheel Nut Torque under
Capacities and Specifications on page 6 108.
WARNING:
Rust or dirt on a wheel, or on the parts to
which it is fastened, can make wheel nuts
become loose after time. The wheel could
come off and cause an accident. When you
change a wheel, remove any rust or dirt from
places where the wheel attaches to the
vehicle. In an emergency, you can use a
cloth or a paper towel to do this; but be
sure to use a scraper or wire brush later,
if needed, to get all the rust or dirt off. See
Changing a Flat Tire on page 6 80.
Lightly coat the center of the wheel hub with
wheel bearing grease after a wheel change or tire
rotation to prevent corrosion or rust build-up. Do
not get grease on the flat wheel mounting surface
or on the wheel nuts or bolts.
I n f o r ma t i o n P r o v i d e d b y :