Page 2
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
CDX-CA600/CA600X SECTION 1 GENERAL 3 7 63 1515 0 This section is extracted from instruction manual. (CDX-CA600/CA600X: AEP, UK model) (CDX-CA600X: E model) L 13942296513 (CDX-CA600/CA600X: AEP, UK model) (CDX-CA600X: E model) u163 http://www.xiaoyu163.com...
CDX-CA600/CA600X SECTION 2 DISASSEMBLY 3 7 63 1515 0 Note : This set can be disassemble according to the following sequence. 2-5. CHASSIS (T) SUB ASSY 2-1. PANEL (1) ASSY, SUB (Page 9) (Page 7) 2-6. LEVER SECTION 2-7.
CDX-CA600/CA600X 3 7 63 1515 0 2-2. CD MECHANISM BLOCK 7 bracket (CD) 5 CD mechanism block 6 PTT 2.6x6 2 PTT 2.6x6 1 PTT 2.6x6 L 13942296513 4 CNP701 2-3. MAIN BOARD 3 screw (+BTT) 5 MAIN board 4 screws (+BTT) 2 PTT 2.6x8...
CDX-CA600/CA600X 3 7 63 1515 0 2-4. HEAT SINK 6 heat sink 5 PTT 2.6x8 4 PTT 2.6x8 3 PTT 2.6x12 2 PTT 2.6x8 1 PTT 2.6x8 L 13942296513 2-5. CHASSIS (T) SUB ASSY 2 P 2x3 3 P 2x3...
Rotary commander key signal input from remote in jack (CNP801) QUALITY Noise detection signal input from RDS decoder (IC601) MPTH Multipass detection signal input FUNCSEL Destination set up detection signal input (“L”: CDX-CA600X, “H”: CDX-CA600) VREF — A/D converter power supply — Power supply (+5 V) input pin OSCOUT High speed clock signal output (18.432 MHz)
Page 14
CDX-CA600/CA600X 3 7 63 1515 0 Pin No. Pin Name Pin Description TSTB CD text parameter strob signal output to servo IC (IC1) RFOK RF OK signal input from servo IC (IC1) CD RST Reset signal output to servo IC (IC1) Command/parameter identification signal output to servo IC (IC1) “L”: Command, “H”: Parameter...
CDX-CA600/CA600X 3-6. PRINTED WIRING BOARDS — CD MECHANISM SECTION — • Refer to page 17 for Circuit Boards Location. 3 7 6 3 1 5 1 5 0 THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
Page 19
CDX-CA600/CA600X 3 7 6 3 1 5 1 5 0 • Semiconductor Location Ref. No. Location (Page 21) 1 3 9 4 2 2 9 6 5 1 3 w w w u 1 6 3 http://www.xiaoyu163.com...
CDX-CA600/CA600X SECTION 4 EXPLODED VIEWS 3 7 63 1515 0 NOTE: The components identified by • The mechanical parts with no reference • Color Indication of Appearance Parts mark 0 or dotted line with mark number in the exploded views are not supplied.
CDX-CA600/CA600X 3 7 63 1515 0 4-5. CD MECHANISM SECTION (3) (MG-393XA-121//K) M901 M902 L 13942296513 The components identified by mark 0 or dotted line with mark 0 are critical for safety. Replace only with part number specified. Ref. No.
CDX-CA600/CA600X SECTION 5 DISPLAY ELECTRICAL PARTS LIST 3 7 63 1515 0 NOTE: • Due to standardization, replacements in • Items marked “*” are not stocked since The components identified by mark 0 or dotted line with mark the parts list may be different from the they are seldom required for routine service.
Page 34
CDX-CA600/CA600X DISPLAY 3 7 63 1515 0 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark D579 8-719-053-09 LED SML-310VTT86 (ATT) (CA600X) < LIQUID CRYSTAL DISPLAY > D580 8-719-038-05 LED CL-190FG-CD-T (AF) (CA600) D580 8-719-053-09 LED SML-310VTT86 (AF) (CA600X)
Page 35
CDX-CA600/CA600X DISPLAY IN SELF SW MAIN 3 7 63 1515 0 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R560 1-220-373-11 RES-CHIP 1/16W R598 1-216-819-11 METAL CHIP 1/16W R561 1-216-819-11 METAL CHIP 1/16W (CA600) R562...
Page 42
CDX-CA600/CA600X 3 7 63 1515 0 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page.