Table of Contents
Advertisement
REMOVING & REPLACING THE PEEL
Remove the Peel and replace the Peel with one of the included Peels as follows:
1
To remove the Peel, hold the unit as shown
at the figure.
3
To replace the Peel, pull out the USB cover
slightly.
5
Make sure the USB cover is inserted through
the USB hole in the peel (a), then press the
middle area of the peel unit it locks in place.
NOTE: Before removing the Peel, make sure the headphones are removed from the Headphone jack.
2
Then pull out the Peel from the top edge.
4
Make sure the tabs at the Peel are aligned
to the corresponding slots on the main unit.
6
a
Press on the left and right side of the
peel until it is securely on the unit (a).
Replace the USB cover (b).
7
b
a
Advertisement
Table of Contents
