Display Screen Messages - AT&T 1070 Quick Reference Manual

http://www.ochimp.com/

Display screen messages

AC FAIL
COVM
COVM
   4
DND
DTAD: XX/YY
(EMPTY)
EXT XX RING
FULL!
INITIALIZING. .
INTERCOM FROM XX
(LIST EMPTY)
LOW BATT
LOWER
http://www.ochimp.com/
There is no AC power to the set. If a good
battery is installed, basic phone operation (such
as making and answering calls on the handset)
is supported. Speakerphone, headset and call
privacy are not supported. The handset volume
will be at the minimum level and only the
two lowest levels of the ringer volume will be
available.
The telephone is ready to receive a voice mail
signal from your local telephone company.
There are new voice mail messages.
The Do Not Disturb mode is on.
Flashes when the mailboxes of the DTAD mailbox
080 telephone are full or when the auto
attendant of the DTAD mailbox 080 telephone
is off. (XX is the total number of new system
extension messages recorded for this 070
telephone. YY is the total number of all system
extension messages recorded for this 070
telephone.)
The directory or one-touch location is empty.
There is an incoming Centrex call.
The directory is full.
The telephone is warming up after having its
power connected.
The telephone is receiving a call from extension
XX (XX is the extension number).
The redial memory is empty.
There is no spare battery in the telephone or the
battery power is low.
The [LOWER] key is pressed to access and dial
the number stored in the lower section of a one-
touch key.
4
Continued on next page