Compliance With Fcc Regulations; Specifications - AT&T LoudSpeak’r BTS01 User Manual

Compliance with FCC Regulations

The equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate Radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to Radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to Radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced Radio/television technician for assistance.
THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE SPEAkER ARE SUBJECT TO CHANGE WITHOUT
PRIOR NOTICE.
If at any time in the future you should need to dispose of this product, please
note that: waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your local authority or
retailer for recycling advice.
Page 12

Specifications

- Full-range dual 35mm driver + passive radiator
- Distortion <= 10%
- Frequency response: 200 Hz - 15k Hz
- Li-ion battery: 700mAh
- Playtime: up to 5 hours
- Charging time: 2 hours
- Bluetooth 2.1 + EDR
- Bluetooth compatibility: Bluetooth 2.0 or above device
with A2DP/AVRCP/HFP/HSP
Page 13