Table of Contents
Advertisement
DOWN SAMPLING
1
1
3
2
1
Select when using the SPDIF setting.
While in the Audio Setup menu, select Audio Output using
the Navigation (π,†) buttons 1, then press the Navigation
(®) button 2 to enter.
Select Down Sampling using the Navigation (π,†) buttons
1, then press the Navigation (®) button 2 to select.
Select the desired option using the Navigation (π,†)
buttons 1, then press the ENTER button 3.
48K: Select this if your A/V Receiver or Amplifier is NOT
capable of handling 192 KHz or 96 KHz signal. When this
choice is made, this unit automatically converts any 192 KHz
and 96 KHz signals to 48 KHz so your system can decode
them.
96K: Select this if your A/V Receiver or Amplifier is NOT
capable of handling 192 KHz signals. When this choice is
made, this unit automatically converts any 192 KHz signals
to 96 KHz so your system can decode them.
192K: Select this if your A/V Receiver or Amplifier is capable
of handling 192 KHz signals.
NOTE: Check the documentation for your A/V Receiver or
Amplifier to verify its capabilities.
INFORMATION MENU:
To enter the Information menu, press the SETUP button, select the Information icon using the
Navigation (√,®) buttons and then press the Navigation (†) button. The Software version
and the MAC will appear.
SETUP MENU (CONTINUED)
Setup Menu
--- Audio Setting ---
Audio Output
SPDIF
Bitstream
HDMI
PCM
Down Sampling
48K
DRC
On
Use cursor keys to move focus, use
SETUP
Exit
"ENTER" key to select
Setup Menu
--- Audio Setting ---
Audio Output
Configuration
Speaker Setting
Use cursor keys to move focus, use
SETUP
Exit
"ENTER" key to select
DRC
1
1
3
2
1
When a disc encoded in Dolby Digital or Dolby Digital Plus is
playing back, you may wish to compress the dynamic range
of the audio output (the difference between the loudest
sounds and the quietest ones). This allows you to listen to a
movie at a lower volume without losing clarity.
While in the Audio Setup menu, select Audio Output using
the Navigation (π,†) buttons 1, then press the Navigation
(®) button 2 to enter.
Select DRC using the Navigation (π,†) buttons 1, then
press the Navigation (®) button 2 to select.
Select ON to enable this effect, OFF to disable, or Auto to let
the unit automatically activate this effect when it can, using
the Navigation (π,†) buttons 1, then press the ENTER
button 3.
30
Setup Menu
--- Audio Setting ---
Audio Output
SPDIF
Bitstream
HDMI
PCM
Down Sampling
48K
DRC
On
Use cursor keys to move focus, use
SETUP
Exit
"ENTER" key to select
Setup Menu
--- Audio Setting ---
Audio Output
Configuration
Speaker Setting
Use cursor keys to move focus, use
SETUP
Exit
"ENTER" key to select
Setup Menu
--- System Information ---
Software Version: Will Appear Here
MAC: XX-XX-XX-XX-XX-XX
Use cursor keys to move focus, use
SETUP
Exit
"ENTER" key to select
Advertisement
Table of Contents
