Network Setup Menu; Information Setup Menu; Quick Setup Menu - Memorex MVBD2535 User Manual

NETWORK SETUP MENU:
To enter the Network Setup menu, while no disc is inserted or disc is in the Stop mode, if not already at the Setup screen press
the HOME/SETUP button, select Settings using the Navigation (π,†) buttons and then press the Navigation (®) button.
Select Network using the Navigation (π,†) buttons and then press the Navigation (®) button.
CONNECTION
If using a wired internet connection, select WIRED using the
Navigation (π,†) buttons, then press the ENTER button,
and the unit will automatically be configured to access the
internet. If successful, you will get the message, Wired
network connection successfully set up.
If using a wireless internet connection, see pages 41-42.
NETWORK TEST
The unit will perform a network test. When the test is
complete, a confirmation window will appear. Press the
ENTER button to select "OK".
If the test fails, double-check your Ethernet cable connection,
wireless router, IP settings, or contact your ISP.
INFORMATION SETUP MENU:
To enter the Network Setup menu, while no disc is inserted or disc is in the Stop mode, if not already at the Setup screen press
the HOME/SETUP button, select Settings using the Navigation (π,†) buttons and then press the Navigation (®) button.
Select Info using the Navigation (π,†) buttons and then press the Navigation (®) button. The information on the unit, such
as Software Version, Software Date, Hardware Version, etc. will appear. These items cannot be changed.
QUICK SETUP MENU:
To enter the Quick Setup menu, while no disc is inserted or disc is in the Stop mode, if not already at the Setup screen press the
HOME/SETUP button, select Settings using the Navigation (π,†) buttons and then press the Navigation (®) button. Select Quick
Setup using the Navigation (π,†) buttons and then press the Navigation (®) button. If you select "Yes, perform Quick Setup", you
can select OSD language, Resolution and TV aspect, or select "No, thanks. I'll go through the full setup menu later" to return to the
previous menu.
SETUP MENU (CONTINUED)
MANUAL NETWORK SETUP
Link Status: If the network connection is active, "Link Up"
appears below Link Status. If the network connection is not
active, "Link Down" displays below Link Status.
MAC Address: This will show the MAC Address.
IP Mode: Select Off to disable the interface. Select Manual
to manually configure network settings, such as IP address,
subnet mask, and gateway settings. Select Dynamic to use
the DHCP to automatically obtain the IP Address.
You can configure the IP Address, Subnet Mask, Gateway,
Primary DNS and Secondary DNS, but it is not recommended
unless informed to do so by your ISP provider. Press the
ENTER button when confirming these options.
39