Table of Contents
Advertisement
111983_09a_STS_GTK_042908.qxd:STS 2007 A
After two consecutive remote starts,
no additional remote starts are
allowed until the vehicle has
been started.
The remote start system will
not operate if the hood or a door
is open.
Starting the Vehicle
1. Aim the transmitter at
the vehicle.
2. Press and release the
button on the transmitter.
3. Immediately press and hold the
(Remote Start) button for at
least three seconds.
4. When the parking lamps flash,
release the button. The engine
will start and the parking lamps
will remain on. The engine will
continue to run for 10 minutes.
5. Repeat these steps for a
10-minute time extension.
When you enter the vehicle after a
remote start, press the brake pedal
and press the Start button to
transition to normal vehicle
operation before driving.
4/29/08
5:18 PM
S
Note: If the Check Engine light is
illuminated on the instrument panel cluster,
Adaptive Remote Start cannot be used. See
your dealer for the proper repairs.
Canceling a Remote Start
If you wish to turn off the engine
instead of driving after a remote
start, perform one of the
following functions:
• Press and hold the Remote Start
button until the parking lamps
turn off.
(Lock)
• Press and release the Hazard
Warning Flashers button inside
the vehicle. Press the button again
to turn off the flashers.
• Press the Off/Accessory button on
and then off.
• The engine will automatically stop
when time expires.
VOICE RECOGNITION
(if equipped)
Page 10
T
S
This feature allows for hands-free
operation of your navigation and
audio system. It can be used when
the ignition is in the On or
Accessory position. The system is
programmed for the English
language only.
Using Voice Recognition
1. Press the
steering wheel until a beep
sounds. Voice recognition is
active when the microphone
symbol is displayed on the
navigation screen.
2. Clearly speak one of the
available commands listed in
your Navigation manual. The
system will repeat and implement
the command.
If the system does not recognize
a spoken command, try again. If a
spoken command is not available,
the system will inform you of its
status. For optimum functionality,
keep interior noise levels to a
minimum; otherwise, the
system may not understand
the command.
(Talk) button on the
Advertisement
Table of Contents
