Seals - Yanmar 1GM10 Shop Manual

GENERAL INFORMATION
b. Remove the housing from the oven or hot plate and
hold onto the housing with a kitchen potholder,
heavy gloves or heavy shop cloths-it is hot.
NOTE
A suitable size socket and extension works
well for removing and installing bearings.
c. Hold the housing with the bearing side down and
tap the bearing out. Repeat for all bearings in the
housing.
d. Prior to heating the bearing housing, place the new
bearing in a freezer, if possible. Chilling a bearing
will slightly reduce its outside diameter, while the
heated bearing housing assembly will be slightly
larger due to heat expansion. This will make bear-
ing installation much easier.
NOTE
Always install bearings with the manufac-
turer b mark or number facing outward.
e. While the housing is still hot, install the new bear-
Seals (Figure 57) are used to contain oil, water, grease
or combustion gasses in a housing or shaft. Improper re-
moval of a seal can damage the housing or shaft. Improper
installation of the seal can damage the seal. Note the fol-
lowing:
1. Prying is generally the easiest and most effective
method of removing a seal from a housing. However, al-
ways place a rag underneath the pry tool to prevent dam-
age to the housing.
2. Pack grease in the seal lips before the seal is installed.
3. Always install seals so that the manufacturer's num-
bers or marks face out.
4. Install seals with a socket placed on the outside of the
seal as shown in Figure 58. Make sure the seal is driven
squarely into the housing. Never install a seal by hitting
against the top of the seal with a hammer.
Tables 1.4 are on the following pages.
i n g ( ~ ) into the housing. Install the bearings by hand,
if possible. If necessary, lightly tap the bearing(s)
into the housing with a socket placed on the outer
bearing race. Do not install new bearings by driving
on the inner bearing race. Install the bearing until it
seats completely.

SEALS

23