The following chart illustrates the configuration procedure.
Remote server
Configure the remote server (see
page 110).
Operating the recording software
on the server by remote access.
Note
To use as a remote server, you must assign an IP address or domain name in order
to connect to this software. An IP address can be obtained from your provider. A
domain name can be obtained by registering with the Panasonic Viewnetcam.com
service.
If you have already registered with Panasonic Viewnetcam.com, use the domain
name obtained when you registered. For details about Viewnetcam.com, see the
operating instructions for your Network Camera.
Remote client
Configure the remote client
(see page 112).
Set an access point server
(remote server) (see page 113).
Connect with administrator or
general user privileges.
Operating Instructions
109