A1200S, A1225S Programming Instructions - Amana A1200S Service

A1200S, A1225S Programming Instructions

!
The scanner is designed to cook foods by scanning the
food item's Universal Product Code (UPC) or by manually
operating the oven.
Scanner Window—Used to scan product UPC.
Display Window—Shows time countdown during
cooking, reheating, or defrosting and show messages.
When the oven is in an idle state the Display Window
always flashes "READY TO SCAN".
Quantity Cooking ("X2", "X3", "X4")—Use to cook 2, 3,
or 4 food items that have the same UPC.
Cancel Pad ("CANCEL")—If pressed once, the UPC or
programming that is in process is stopped and the Display
Window flashes 'READY TO SCAN".
RE220002 Rev. 6
WARNING
To avoid risk of electrical shock, personal injury, or death,
disconnect power to unit and discharge the capacitor
before following any disassembly procedures.
Display Messages
This oven will display a number of messages when
programming or during various oven operations.
READY TO SCAN—When plugged in, the Display
Window will flash "READY-TO-SCAN".
PLACE FOOD IN OVEN—this message will flash after
the bar code has been scanned and the recipe is in the
memory.
RESUME OR CANCEL—This message will flash
whenever the door is opened during cooking.
READY TO ENJOY—After cooking cycle, this message
will flash until the door is opened to remove the food.
The oven will beep while the message is flashing.
THANK YOU—After cooking is complete and the door
is opened, this message will flash once.
NOT IN MEMORY—This message will flash when a bar
code is scanned and the recipe is not in memory. This
message lasts only until the beeps have sounded, then
the Display Window will flash "READY-TO SCAN".
SCAN—This message is displayed when the bar code
is scanned, but not read correctly. Scan the bar code
again.
WAIT—This message is displayed while the oven is
searching its memory for a stored recipe after a bar
code has been scanned.
UPROG—This programming message is displayed to
indicate that the oven is ready to be programmed.
IN MEM—This message is displayed to indicate the
UPC just scanned is stored in memory.
50