Toshiba SD-1200 Service Manual page 66

1-2-3. Power PC board
1. Peel off the tape (1).
2. Remove the connectors (2) and (3).
3. Remove three screws (4).
4. Remove two screws (5).
5. Release two claws and remove the power supply PC
board (6).
Note:
• When mounting, be sure to twist the wire for the
connectors (2) and (3) several times.
Power supply
PC board (6)
Screws (4)
Connector (3)
Claws
Twist more than 7 times.
Fig. 2-1-11
Twist more than 9 times.
Connector (2)
Screws (5)
Tape (1)
1-2-4. Front PC Board
1. Remove the front panel. (Refer to item 1-1-4.)
2. Remove four screws (1) and remove the front display
PC board (2)
3. Remove two screws (3) and remove the power switch
PC board (4).
Power SW
PC board (4)
Fig. 2-1-12
Screws (3)
Front display
PC board (2)
Screws (1)