Toshiba SD-1200 Service Manual page 64

Tray panel (4)
A
Tray (3)
Fig. 2-1-5
1-1-4. Front Panel and Tray
1. Remove the flexible cable (1).
2. Remove one screw (2) and remove the GND lead (3).
3. Release four claws and remove the front panel (4).
4. Pull out the tray (5) to this side.
Screw (2)
GND lead (3)
Claw
Tray (5)
Claws
Front panel (4)
Fig. 2-1-6
Note:
• Insert the tray (3) with the front side of the pickup
mechanism assembly descended. (The slider positions
to the left side.)
• The gears are required to match their phases each
other. After setting the gear (4) as shown in the figure
"A", insert the tray (3). When inserting a tray (3), push
the rack gear side shown by the arrow.
Tray (3)
B
Tray panel (4)
Claws
Flexible cable (1)
Claw
• After inserting the tray (3), confirm that the mark of
the gear (4) matches with that of the rack gear on the
tray (first tooth of the gear). (Refer to Fig. B.)
Gear (4)
The first tooth of the gear of
this side on the tray rack gear.
Rack gear
Marking
Figure B
1-1-5. Rear Panel
1. Remove three screws (1) and remove the rear panel (2).
Figure A
Triangle mark
Position of the line
Pickup mechanism
assembly
Gear (4)
Slider
Tray (3)
Gear (4)
Fig. 2-1-7
Rear panel (2)
Screws (1)
Fig. 2-1-8