Troy-Bilt TB42 BC Operator's Manual
  1. Manuals
  2. Brands
  3. Troy-Bilt Manuals
  4. Trimmer
  5. TB42 BC
  6. Operator's manual

Troy-Bilt TB42 BC Operator's Manual

Hide thumbs Also See for TB42 BC:
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

See also: Operating Manual
Removing Unit From Carton
Assemble The Unit
1 1
2
Remove cap from end of
Remove all contents from
the carton.
lower boom. Push cutting
attachment add-on into
coupler. Turn coupler knob
clockwise to tighten.
Assemble The Unit
40:1
1 Gallon
3.2 oz
4
5
Mix thoroughly in separate
Place unit on a level surface.
fuel can:
Fill fuel tank.
– 3.2 fl. oz. of 2-cycle
engine oil
– 1 gallon of unleaded
gasoline
NOTE: Do not mix directly in
fuel tank.
Starting The Unit
1 8
9
Crouch in starting position.
SQUEEZE and HOLD
throttle for ALL further
steps.
IMPORTANT: READ THE OPERATOR'S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
NEED HELP?
769-07387 P01
Operator's Manual
Arrow
Decal
3
Place the J-handle between the top and middle clamps,
slide the 4 screws through the clamps, and place the
assembly onto the bottom clamp. Start the screws,
then ensure the arrow/ white line on the decal touches
the clamp assembly. Position the J-handle to the
location that provides the best grip, then tighten the
screws evenly until the J-handle is secure.
Starting The Unit
Primer
Choke Lever
Bulb
10 X
6
7
Press primer bulb 10 times,
Move choke lever to
or until fuel is visible
Position 1.
Choke Lever
5 X
10
11
Pull rope 5 times.
Move choke lever to
Position 2 and squeeze
throttle.
CALL 1-800-828-5500 IN U.S. OR 1–800–668–1238 IN CANADA
Electric Starter or
Power Start Bit Optional!
THESE OPTIONAL ACCESSORIES
ARE SOLD SEPARATELY!
This unit has an alternate starting method
that many find easier to use than pulling a
rope. Please contact a local retailer or call
1-800-828-5500 for more information.
On/ Off Switch
Information may also be found at
www.troybilt.com
J-Handle
Ez-Link™
Cutting Head Shield
3-5 X
12
13
Pull rope 3-5 times to start
Continue to squeeze
engine. Run unit for 30-60
throttle. Move choke lever
seconds to warm up.
to Position 3.
TB42 BC
2-Cycle Trimmer
Starter Rope
Fuel Cap
Throttle Control
ASSEMBLY TOOLS
REQUIRED:
• Phillips screwdriver
Need Help?
Call 1-800-828-5500
DIDN'T START?
Repeat these instructions.
IF engine fails to start after 2 attempts,
move choke lever to position 3 and pull
the starter rope until engine starts
IF unit still fails to start, refer to operator's
manual for additional starting and
troubleshooting information
Choke Lever
14
Continue to squeeze
throttle. Run unit for an
additional 60 seconds to
complete warm-up. Unit
may be used during this
time.
11/11

Advertisement

Table of Contents
loading

Related Manuals for Troy-Bilt TB42 BC

Summary of Contents for Troy-Bilt TB42 BC

  • Page 1 TB42 BC 2-Cycle Trimmer Operator’s Manual Removing Unit From Carton Assemble The Unit Electric Starter or Starter Rope Power Start Bit Optional! THESE OPTIONAL ACCESSORIES Fuel Cap ARE SOLD SEPARATELY! This unit has an alternate starting method that many find easier to use than pulling a rope.

  • Page 2: Table Of Contents

    TABLE OF CONTENTS RULES FOR SAFE OPERATION Service Information ..............2 Rules for Safe Operation .

  • Page 3: Know Your Unit

    KNOW YOUR UNIT ASSEMBLY INSTRUCTIONS APPLICATIONS Choke Lever REMOVE AND INSTALL THE CUTTING ATTACHMENT SHIELD As a trimmer: Spark Plug WARNING: Cutting The cutting attachment Screws (3) • Cutting grass and light weeds. Starter Attachment shield should NOT be installed when Rope Shield •...

  • Page 4: Oil And Fuel Information

    ASSEMBLY INSTRUCTIONS Install the Cutting Blade CAUTION: For proper engine operation and maximum WARNING: To avoid serious personal injury, always wear gloves while handling or installing the reliability, pay strict attention to the oil and fuel mixing instructions blade. on the 2-cycle oil container. Using improperly mixed fuel can severely damage the engine.

  • Page 5: Operating Instructions

    OPERATING INSTRUCTIONS MAINTENANCE AND REPAIR INSTRUCTIONS MAINTENANCE SCHEDULE HOLDING THE TRIMMER WARNING: To prevent serious injury, never perform maintenance or repairs with unit running. Always WARNING: Always wear eye, hearing, foot and body protection to reduce the risk of injury service and repair a cool unit.

  • Page 6: Cleaning And Storage

    MAINTENANCE AND REPAIR INSTRUCTIONS TROUBLESHOOTING CAUSE ACTION AIR FILTER MAINTENANCE ENGINE WILL NOT START WARNING: To avoid serious personal injury, always turn the unit off and allow it to cool before you clean or service it. Empty fuel tank Fill fuel tank with properly mixed fuel The primer bulb wasn't pressed enough Press the primer bulb 10 times or until fuel is visible Cleaning the Air Filter...
  • Page 7 NOTES...
  • Page 8 TB42 BC Recortador de 2 Ciclos Manual del Operador Cuerda de arranque Sacar la unidad de la caja Ensamblado de la unidad ¡Arranque eléctrico o accesorio de arranque eléctrico opcional! ¡ESTOS ACCESORIOS OPCIONALES SE VENDEN POR SEPARADO! Interruptor de Esta unidad posee un método de arranque...
  • Page 9 INDICE DE CONTENIDOS NORMAS PARA UNA OPERACION SEGURA Llamadas a apoyo al cliente ............9 Normas para una operación segura .
  • Page 10 CONOZCA SU UNIDAD INSTRUCCIONES DE ENSAMBLE APLICACIONES Bujía de encendido Palanca del obturador REMOCIÓN E INSTALACIÓN DEL PROTECTOR ACCESORIO DE CORTE Como recortadora; Mango de la ADVERTENCIA: Protector El protector accesorio Tornillos (3) cuerda de • Corte de césped y hierbas delgadas Silenciador accesorio de de corte NO debe estar instalado cuando...
  • Page 11 INSTRUCCIONES DE ENSAMBLE INFORMACIÓN DEL ACEITE Y DEL COMBUSTIBLE IInstalación de la cuchilla de corte INSTRUCCIONES PARA MEZCLAR EL ACEITE Y EL COMBUSTIBLE El combustible viejo o mal mezclado son los motivos principales del mal ADVERTENCIA: Para evitar graves lesiones personales, el protector accesorio de corte DEBE estar funcionamiento de la unidad.
  • Page 12 SI VA A UTILIZAR EL ARRANCADOR ELÉCTRICO O ACCESORIO DE POWER START BIT™ OPCIONAL USO DE LA CUCHILLA DE CORTE Antes de operar la unidad con la cuchilla de corte, párese en posición de corte (Fig. 23). Lea Cómo sostener el Recortador. ADVERTENCIA: Use siempre protección para sus ojos, audición, pies y cuerpo para reducir el riesgo de una lesión al operar esta unidad.
  • Page 13 INSTRUCCIONES DE MANTENIMIENTO Y REPARACIÓN INSTRUCCIONES DE MANTENIMIENTO Y REPARACIÓN MANTENIMIENTO DEL FILTRO DE AIRE INSTALACION DE LA LINEA Esta sección cubre la instalación de la línea SplitLine™ y de la línea individual regular. ADVERTENCIA: Para evitar graves lesiones personales, apague siempre su recortador y espere que se enfríe antes de limpiarlo o realizar todo tipo de mantenimiento.
  • Page 14 RESOLUCIÓN DE PROBLEMAS LIMPIEZA Y ALMACENAMIENTO CAUSA ACCIÓN LIMPIEZA EL MOTOR NO ARRANCA ADVERTENCIA: Para evitar graves lesiones personales, apague siempre su recortador y espere que se enfríe antes de limpiarlo o realizar cualquier tipo de mantenimiento. El tanque de combustible está vacío Remplissez-le de carburant bien mélangé.
  • Page 15 NOTES...

  • Page 16: Warranty Information

    Troy-Bilt LLC concede la garantía limitada establecida debajo para mercancías nuevas que sean compradas y usadas en los Estados Unidos, sus posesiones y territorios. Troy-Bilt LLC garantiza este producto contra defectos en el material y la mano de obra durante un período de dos (2) años, a partir de la fecha de compra original y a su entera discreción, arreglará o substituirá sin costo alguno cualquier pieza cuyo material o mano de obra se considere defectuoso.

Table of Contents