Pedal Hubs
Pedal Axle
Assembly
5
• While holding the pedal hubs on the pedal axle assembly,
insert the pedal axle through the hole in the center of the
front wheel.
• Push the pedal hubs into the center of the front wheel until
they are flush with the surface of the front wheel.
Pedal Hub
6
• Turn the front wheel assembly over.
• Insert the remaining pedal hubs on top of and below the
pedal axle and into the hole in the center of the front wheel.
• Push the pedal hubs into the center of the front wheel until
they are flush with the surface of the front wheel.
Assembly
Front Wheel
Pedal Hub
4
7
• Fit the pedal on the pedal axle. Tap the pedal with
a hammer until it is secure.
• Pull the pedal up to be sure it is secure. If you can remove
it, you have not secured it properly. Tap it with the
hammer again.
Fork Cover
8
Pedal Axle
• Place the front wheel assembly between the fork arms.
Make sure the pedal axle fits into the groove at the bottom
of each fork arm.
• Place a fork cover over the pedal axle on one fork arm.
• Insert two #8 x
/
" (1,9 cm) screws into the fork cover
3
4
and tighten.
• Repeat this procedure to attach the other fork cover to the
other fork arm.
Pedal
Pedal Axle
Scrap Block
of Wood
Fork Arms
Groove