Register Your Product For Services And Repair; Safety Information; Approved Channels - 3Com AirConnect 9550 Quick Start Manual

Register Your Product for Services and Repair

To obtain telephone support as part of your warranty and other service benefits, you must first
register your product at:
http://eSupport.3com.com/
Telephone Technical Support and Repair
3Com offers telephone, e-mail, and Internet access to technical support and repair services. To
access these services for your region, use the appropriate telephone number, URL, or e-mail
address from the following URL:
http://csoweb4.3com.com/contactus/

Safety Information

This equipment must be installed in compliance with local and national building codes, regulatory
restrictions, and FCC rules. For the safety of people and equipment, only professional network
personnel should install the AP.
WARNING: Warnings contain directions that you must follow for your personal safety.
Follow all directions carefully.
You must read the following safety information carefully before you install or remove the
unit.
WARNING: Exceptional care must be taken during installation and removal of the unit.
WARNING: This unit operates under SELV (Safety Extra Low Voltage) conditions
according to IEC 950 / IEC 60950. The conditions are only maintained if the equipment
to which it is connected also operates under SELV conditions.
WARNING: There are no user-replaceable fuses or user-serviceable parts inside the
unit. If you have a physical problem with the unit that cannot be solved with problem
solving actions in this guide, contact your supplier.
WARNING: RJ-45 ports. These are RJ-45 data sockets. They cannot be used as
standard traditional telephone sockets, or to connect the unit to a traditional PBX or
public telephone network. Only connect RJ-45 data connectors, network telephony
systems, or network telephones to these sockets.
Either shielded or unshielded data cables with shielded or unshielded jacks can be
connected to these data sockets.
WARNING: To comply with FCC radio frequency (RF) exposure limits, a minimum
body-to-antenna distance of 20 cm (8 in.) must be maintained when the AP is
operational.

Approved Channels

Use of this product is only authorized for the channels approved by each country. For proper
installation, select your country from the country-selection list.
To conform to FCC and other country restrictions, your product may be limited in the channels
that are available. If other channels are permitted in your country, please visit the 3Com web site
for the latest software version:
www.3Com.com
3